Cellar 7 Wine Kit Instructions


All equipment must be sterilised before use

You will need the following equipment: 

2 x 25 litre Wine Fermenters - one for fermentation and one for transferring/racking

Airlock and Bung - to allow the release of gas produced during fermentation

Spoon - to stir/degass your brew

Hydrometer - to check that the fermentation process is complete Syphon - to transfer from fermenter for racking

Steriliser - to sterilise equipment before use 

Additional Recommended Equipment:

Hyrodmeter/Trial Jar - to check specific gravity during wine making

Degasser - to remove C02 gas from wine

All equipment is available from us. Click here to view

IMPORTANT: Please read all instructions before beginning.

Day 1

Record the date and your SG reading. Keep safe for future reference
1. Empty the grape juice into your fermenting vessel. Top up with lukewarm water (20-25C) to 21 litres.

2. Sprinkle in Pack A (Wine Yeast/Nutrient) and mix well.

3. Fit the Airlock/Bung. The Airlock should be half filled with water. Place the Fermenter in a warm environment (20-25C) and where there is a minimal risk of damage if fermentation is vigorous which may cause frothing or leakage. Fermentation should start within 24 hours. You will notice this by seeing C02 gas bubbles in the airlock and a frothy layer on the liquid surface.

Day 5

Record the date and SG reading

4. Fermentation should be complete. You will no longer see bubbles passing through the Airlock. It is recommended that you use a Hydrometer to check the Specific Gravity of the wine. If the S.G. is 1.000 or below move on to the next stage. Alternatively, taste the wine. If it is too sweet leave it for a couple of days before proceeding.

5. Syphon / Rack the wine into another sterilised fermenter making sure that all the sediment is left behind. Stir the wine well for 1 minute to get rid of the C02. Repeat this 2-3 times leaving a few minutes in between. This will help with the clearing of your wine.

6. Add Pack C (Stabiliser) and mix thoroughly.

7. After 3 hours add Pack E (Finings 1) mix well and leave for 1 hour.

8. After 1 hour add Pack F (Finings 2) and mix well. Leave the wine to clear. The fermenter should be placed at table height so that you can transfer ready for Bottling / Storage. During the next 48hrs your wine will clear. Before proceeding to the next stage, ensure that your wine is thouroghly clear.

Day 7

9. Syphon the wine into bottles / suitable storgage container and seal. Taking care not disturb any further residual sediment in the bottom of the fermenter. The wine is now ready to drink, but will improve if left in a cool dry place for a few weeks.

Happy Brewing!

Home Brew Online