(0)
£0.00

Product Reviews for Nylon Small Bottle Brush

Return to Nylon Small Bottle Brush ›

1 2

  • Currently 5/5 Stars.

just the job

Fits perfect into the 500ml PET bottles! does an excellent job
Kev
  • Currently 5/5 Stars.

Works well and cleans the bottom

Bristles at the end get into the indents in the bottom of the plastic bottles, so good brush.
David B
  • Currently 3/5 Stars.

The bottle brush.

Very handy brush for cleaning the bottles out, gets rid of any sediment in the bottles & makes it easier to clean them out before filling, the only thing I've noticed is the brush is starting too loose its shape a bit but its still usable & does the job.
Reg
  • Currently 4/5 Stars.

Small bottle brush.

This is good, but does not like very hot water as the nylon disintegrates....MY FAULT
Brian Davey
  • Currently 3/5 Stars.

Size check

The brush is as described, but be aware it is bigger than I thought from the photo. I should have checked the dimensions. I only have small bottles, it still works but I should have paid more attention!!
Andrew
  • Currently 4/5 Stars.

Good quality

This is a well made, good quality bottle brush. The bristles at the bottom fan out meaning they cover the bottom of the bottle and get into the edges to clean. They do tend to then stay fanned out a bit which can make getting it back into the bottle a little tricky again, but it's not a real problem. My only issue (and it's a very minor thing) is that the way the bottom bristles are attached means there is a bit of a gap where the horizontal bristles end and the fan out bristles begin so there is few centimeters at the bottom where the sides aren't touched. This can be remedied by using the fan out bristles to do these bits. And I'm not really sure if the brush could be made any differently, so I think that all in all this brush does its job very well.
Kate
  • Currently 4/5 Stars.

does what is says on tin

Cleans bottles.. what else to say other than perhaps the lack of bristles on the lower section means an area of bottle could be hard to clean if not rinsed directly after use.
Luke
  • Currently 5/5 Stars.

Does the job

Good priced product that works
Andy
  • Currently 2/5 Stars.

Bottle Brush

Does what it says on the tin, however, during first use (after cleaning say 10 bottles, the tip decided to fall off and will not stick back on the top, Little disappointing to be honest!    HBO - Please contact us for a replacement, this brush sounds to be faulty.
Chris
  • Currently 3/5 Stars.

Not bad

This is very good for cleaning the very bottom of the bottles, but it misses a lot of the bottom sides as there are no bristles on the sides at the bottom. I find I use this for the bottom, then a standard one to clean the bottle sides. Annoying I have to use 2 brushes per bottle, but haven't found 1 brush that does everything yet!
Alan Wooler
  • Currently 4/5 Stars.

Nylon Bottle Brush

Service and delivery prompt and efficient as usual thankyou. The brush is effective in cleaning the base and most of the side wall excepting the lowest inch. There must be a market for a brush which can clean the base and all the side wall.
Tim N
  • Currently 5/5 Stars.

Long and Brushy

It gets down to the bottom of the bottles, and other beer making equipment. The shaft is pretty sturdy, and wouldnt bend when using unless you want it to.
  • Currently 5/5 Stars.

Good Value

This bottle brush was cheap but well made, and proved to be perfect for cleaning out pint-sized glass beer bottles. Unlike one other reviewer, I didn't have trouble cleaning the inside-base of the bottles. Recommended!
  • Currently 3/5 Stars.

its a brush

You'd think a beer bottle brush would get every part of a beer bottle , but mine repeatedly failed to get the specks of old beer mould off the bottom inside 'corners' despite bending it to try and get there. It really needs a better designed end or softer bristles. They were 660ml Tiger beer bottles .
  • Currently 5/5 Stars.

Brilliant brush

Reaches the parts many other brushes dont
Return to Nylon Small Bottle Brush ›

1 2